| The TC3001 is a universal high performance
three phase power controller for all loads from 25A-1800A/ 690V max, including
resistive, inductive and temperature dependent complex loads. Self-contained
units are available up to 1000A. Above this the power and control electronics
are separated to extend the range up to 1800A. The TC3001 provides precision
control of direct and transformer connected heaters, variable temperature
coefficient elements (platinum, tungsten, molybdenum disilicide and silicon
carbide), short wave infrared lamps, induction and RF heating and immersed
elements for direct glass heating. |
All protective features of the model
TC3000 are included. Special features include: 5 selectable control modes,
current limit, partial load fail for resistive and infrared loads, soft
start/end ramping, partial load unbalance, analog retransmission of controlled
parameter and multiple status alarms. The TC3001 may be totally controlled
via the communications link, simplifying wiring, saving cost. EI-Bisynch,
JBus, Modbus® and Profibus® protocols are available. It may be
used with the model 260 Diagnostic Unit. |
|
TECHNICAL SPECIFICATIONS
 |
|
Dimensions (mm): |
|
|
|
25 to 250A; |
480H x 248W x 268D;
16kg |
|
|
(250A:18kg)* |
|
300 to 500A |
570H x 373W x 268D;
21kg* |
|
700A to 1000A; |
500H x 377W x 519D;
46kg |
|
1150A to 1350A; |
775H x 582W x 405D;
00kg |
|
1500A to
1800A; |
790H x 641W x 471D;
00kg |
|
|
* Note, 690
volt units below 500amp rating are same size as standard 500 amp unit |
| Operating
temp: |
|
0°C to 45°C,
5-95% RH, non-condensing |
| Mounting: |
|
Panel mounting |
| Load type: |
|
Resistive, inductive,
transformer and complex loads requiring current limit |
| Inputs: |
DC voltage
: |
0 to 5V, 1 to 5V, 0
to 10V or 2 |
|
|
to 10V(impedance 100Kž) |
|
DC current : |
0 to 20mA or 4 to 20mA
(impedance 100ž) |
|
Logic
: |
5V, 10V, 20mA (>50%
ON : |
|
|
<25% OFF) input impedance
as above |
| Firing mode: |
|
Logic, phase angle,
fast cycle and burst with phase angle start/finish |
|
